This flight mode is preferred for forward flight, aerobatics and inverted flying (requires symmetrical main blades).With the included 6-channel FM transmitter featuring servo reversing, CCPM mixing and idle up flight mode switch, youll have precise control.Additional Required Equipment Only 8 AA batteries are required to complete your Blade CP.
![]() Be certain to monitor the charge process, as batteries that are not fully discharged may be fully charged in less than 2.02.5 hours time. ![]() We have main motors in stock and Aerobatic Enhancement Kit equipped models with more than 100 flights that continue to perform very well. We have tail motors in stock and Aerobatic Enhancement Kit equipped models with more than 100 flights that continue to perform very well. Installing the Flight Battery Use the included hook and loop material for mounting the Ni-MH battery pack. You should also use the included rubber bands for the most secure attachment of the battery to the helicopter. With the canopy installed, lift the helicopter by the flybar with the flybar positioned perpendicular to the tail boom. Slide the battery support and battery forward or rearward as required to achieve a slightly nose down or perfectly level helicopter position. Position the helicopter to view it from the left or right side. Move the left-hand stick up and down to check the collective pitch control. When the stick is pushed forward, the swashplate should also tilt forward. With the stick pulled back, the swashplate will tilt toward the rear. When the stick is pushed to the left, the swashplate should also tilt left. With the stick pushed right, the swashplate will tilt to the right. Mac drive 8 serial numberIf you have confirmed proper control operation of your Blade CP, reconnect the main and tail motor wires to the 4-in-1 unit, taking care to keep the proper polarity and location of each as they were before the test. The tail motor plug should be installed into the upper output slot of the 4-in-1 control unit with the positive lead to the top. The proportional trimmer pot adjusts the amount of tail motor to main motor mixing. Proportional Trimmer Pot In hover, with the rudder trim centered and no rudder input, note which direction the nose of the helicopter is trying to spin. Gain Trimmer Pot Pilots interested most in hovering-type maneuvers with very little forward flight and aerobatics may choose to have the gain set as high as possible (without making the tail twitch quickly from side to side), keeping the tail of the helicopter very solid during flight. Visual novel english downloadIn this flight mode, the throttle curve is linear from 0 to 100, with a pitch range of 0 degrees to 10 degrees. See Page 20 for additional data and graphics relating to the throttle and pitch curves preset for your Blade CP.) This is.
0 Comments
Leave a Reply. |
AuthorDustin ArchivesCategories |